HBM Genesis GEN5i User Manual page 170

170
Select the Standard 1 Gbit Ethernet port that is connected to the Ethernet
switch.
Figure 11.21: Network interface connections/Standard 1 Gbit option
4 iSCSI Host
DNS Name/IP Address
l
As the setup is part of a corporate network, a DNS setting should be
used in this setup. Therefore select the DNS name option and use the
same DNS name as was used in the setup of the NAS.
When using a Synology
®
Synology Assistant software. This software displays all the known
connected Synology
(For more information, please refer to Figure J.7 "Create a new iSCSI
target dialog" on page 580).
Port number:
l
Default: 3260
Can sometimes be found in the NAS configuration of the
manufacturers software.
When using a Synology
default of 3260.
5 iSCSI Target
Target name (IQN):
l
This is the IQN name, it can be found by looking at the manufacturers
software supplied with the NAS.
An example for Synology
Use CHAP:
l
Select Use CHAP if CHAP password protection was selected during
the setup of your NAS server. When using a Synology
password protection can be selected.
(For more information, please refer to Figure J.7 "Create a new iSCSI
target dialog" on page 580).
User name:
l
Enter the details used during the setup procedure of the CHAP
authentication on the NAS. If none were chosen, leave these field
blank.
®
NAS, the IP address is displayed in the in the
®
devices.
®
NAS the port number must be set on the
® iSCSI setup you can find on page 574.
GEN5i
(See Figure 11.20 - B)
(See Figure 11.20 - C)
®
NAS, CHAP
I2679-4.0 en