Table of Contents
Advertisement
I2679-4.0 en
Figure 11.71: Perception work area with Master/Slave trigger
A
Settings tab
B
Trigger group
C
Master/Slave trigger column
To set the Master/Slave trigger in the Perception software, proceed as follows:
1
If it is not already active, start Perception.
2
Make sure that you are connected to the required mainframes. Use the
Hardware Navigator to do this.
3
Select the Settings sheet.
4
If it is not already done, switch the Settings sheet layout modes to
Advanced mode.
5
In the Settings sheet, go to the Trigger group in the task pane and select
Recorder.
A list of available recorders is displayed in the settings area.
6
Select the recorder that you want to set.
7
Double-click on the Master/Slave trigger cell to open it for modification.
GEN5i
233
Advertisement
Table of Contents
Troubleshooting
