Functional Testing; Power Transmission; Aligning The Speed Module - HBM T10FM Mounting Instructions

Torque flange

Hide thumbs Also See for T10FM:

Table of Contents

7.3 Functional testing

If you suspect that the transmission system is not working properly, you can

remove the stator cover and test for correct functioning. If the LED is on, the

rotor and stator are properly aligned and there is no interference with the

transmission of measurement signals. When the calibration signal is triggered,

the LED shines more brightly.

Fig. 7.4: Power transmission function test

When required, you can test the correct functioning of the speed measuring

system.

1. Remove the cover of the stator housing.

2. Turn the rotor by at least 2 min

If both the control LEDs come on while you are turning the rotor, the speed

measuring system is properly aligned and fully operational.

Fig. 7.5: Control LEDs of the speed measuring system

HBM

-1.

Green control LEDs

T10FM

Control LED

A0894-5.2 en

Table of Contents