H3C S5120-SI Series Command Reference Manual page 250

Parameters
interface interface-type interface-number: Displays attacking MAC addresses detected on the
interface.
Description
Use the display arp anti-attack source-mac command to display attacking MAC addresses detected
by source MAC address based ARP attack detection.
If no interface is specified, the display arp anti-attack source-mac command displays attacking MAC
addresses detected on all the interfaces.
Examples
# Display the attacking MAC addresses detected by source MAC address based ARP attack detection.
<Sysname> display arp anti-attack source-mac
Source-MAC
23f3-1122-3344
23f3-1122-3355
23f3-1122-33ff
23f3-1122-33ad
23f3-1122-33ce
ARP Packet Rate Limit Configuration Commands
arp rate-limit
Syntax
arp rate-limit { disable | rate pps drop }
undo arp rate-limit
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
disable: Disables ARP packet rate limit.
rate pps: ARP packet rate in pps, in the range 5 to 100.
drop: Discards the exceeded packets.
Description
Use the arp rate-limit command to configure or disable ARP packet rate limit on an interface.
Use the undo arp rate-limit command to restore the default.
By default, ARP packet rate limit is not enabled.
VLAN ID Interface
4094 GE1/0/1
4094 GE1/0/2
4094 GE1/0/3
4094 GE1/0/4
4094 GE1/0/5
2-5
Aging-time
10
30
25
30
2