Ip Https Port - H3C S5120-SI Series Command Reference Manual

Note that enabling of the HTTPS service triggers an SSL handshake negotiation process. During the
process, if a local certificate of the device already exists, the SSL negotiation is successfully performed,
and the HTTPS service can be started normally. If no local certificate exists, a certificate application
process will be triggered by the SSL negotiation. Because the application process takes much time, the
SSL negotiation often fails and the HTTPS service cannot be started normally. Therefore, execute the
ip https enable command for multiple times to ensure normal startup of the HTTPS service.
Related commands: display ip https.
Examples
# Enable the HTTPS service.
<Sysname> system-view
[Sysname] ip https enable

ip https port

Syntax
ip https port port-number
undo ip https port
View
System view
Default Level
3: Manage level
Parameters
port-number: Port number of the HTTPS service, which ranges from 1 to 65535.
Description
Use the ip https port command to configure the port number of the HTTPS service.
Use the undo ip https port command to restore the default.
By default, the port number of the HTTPS service is 443.
Note that this command does not check whether the configured port number conflicts with that of an
existing service. Therefore, ensure that the port number is not used by another service before the
configuration.
Related commands: display ip https.
Examples
# Configure the port number of the HTTPS service as 6000.
<Sysname> system-view
[Sysname] ip https port 6000
2-4