Reset Igmp-Snooping Group - H3C S5120-SI Series Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the report-aggregation command to enable IGMP report suppression.
Use the undo report-aggregation command to disable IGMP report suppression.
By default, IGMP report suppression is enabled.
This command works on IGMP snooping–enabled VLANs.
Examples
# Disable IGMP report suppression.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] undo report-aggregation

reset igmp-snooping group

Syntax
reset igmp-snooping group { group-address | all } [ vlan vlan-id ]
View
User view
Default Level
2: System level
Parameters
group-address: Specifies an IGMP snooping group. The value range of group-address is 224.0.1.0 to
239.255.255.255.
all: Specifies all IGMP snooping groups.
vlan vlan-id: Specifies a VLAN. The effective range of vlan-id is 1 to 4094.
Description
Use the reset igmp-snooping group command to clear IGMP snooping multicast group information.
Note that:
This command works only on IGMP snooping–enabled VLANs.
This command cannot remove the static group entries of IGMP snooping groups.
Examples
# Remove dynamic group entries of all IGMP snooping groups.
<Sysname> reset igmp-snooping group all
1-28