Ntp-Service Unicast-Server - H3C S5120-SI Series Command Reference Manual

No symmetric-passive peer is designated for the device by default.
Examples
# Designate the device with the IP address of 10.1.1.1 as the symmetric-passive peer of the device,
configure the device to run NTP version 3, and specify the source interface of NTP messages as
VLAN-interface 1.
<Sysname> system-view
[Sysname] ntp-service unicast-peer 10.1.1.1 version 3 source-interface vlan-interface 1

ntp-service unicast-server

Syntax
ntp-service unicast-server { ip-address | server-name } [ authentication-keyid keyid | priority |
source-interface interface-type interface-number | version number ] *
undo ntp-service unicast-server { ip-address | server-name }
View
System view
Default Level
2: System level
Parameters
ip-address: IP address of the NTP server. It must be a unicast address, rather than a broadcast address,
a multicast address or the IP address of the local clock.
server-name: Host name of the NTP server, a string of 1 to 20 characters.
authentication-keyid keyid: Specifies the key ID to be used for sending NTP messages to the NTP
server, where keyid is in the range of 1 to 4294967295.
priority: Specifies this NTP server as the first choice under the same condition.
source-interface interface-type interface-number: Specifies the source interface for NTP messages. In
an NTP message the local device sends to the NTP server, the source IP address is the primary IP
address of this interface. interface-type interface-number represents the interface type and number.
version number: Specifies the NTP version, where number is in the range of 1 to 3 and defaults to 3.
Description
Use the ntp-service unicast-server command to designate an NTP server for the device.
Use the undo ntp-service unicast-server command to remove an NTP server designated for the
device.
No NTP server is designated for the device by default.
Examples
# Designate NTP server 10.1.1.1 for the device, and configure the device to run NTP version 3.
<Sysname> system-view
[Sysname] ntp-service unicast-server 10.1.1.1 version 3
1-17