Igmp-Snooping Special-Query Source - H3C S5120-SI Series Command Reference Manual

Description
Use the igmp-snooping router-aging-time command to configure the aging time of dynamic router
ports in the current VLAN.
Use the undo igmp-snooping router-aging-time command to restore the default setting.
By default, the aging time of dynamic router ports is 105 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, router-aging-time.
Examples
# Enable IGMP snooping and set the aging time of dynamic router ports to 100 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping router-aging-time 100
igmp-snooping special-query source-ip
Syntax
igmp-snooping special-query source-ip { ip-address | current-interface }
undo igmp-snooping special-query source-ip
View
VLAN view
Default Level
2: System level
Parameters
ip-address: Sets the source address of IGMP group-specific queries to the specified address.
current-interface: Sets the source address of IGMP group-specific queries to the address of the
current VLAN interface. If the current VLAN interface does not have an IP address, the default IP
address 0.0.0.0 will be used as the source IP address of IGMP group-specific queries.
Description
Use the igmp-snooping special-query source-ip command to configure the source IP address of
IGMP group-specific queries.
Use the undo igmp-snooping special-query source-ip command to restore the default configuration.
By default, the source IP address of IGMP group-specific queries is 0.0.0.0.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable.
1-22