Speed - H3C S5120-SI Series Command Reference Manual

By default, terminal services are available in all user interfaces.
Note the following when using the undo shell command:
This command is available in all user interfaces except the AUX user interface, because the AUX
port (also the Console) is exclusively used for configuring the switch.
This command is unavailable in the current user interface.
This command prompts for confirmation when being executed in any valid user interface.
Examples
# Log into user interface 0 and make terminal services unavailable in VTY 0 through VTY 4.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] undo shell
% Disable ui-vty0-4 , are you sure ? [Y/N]y

speed

Syntax
speed speed-value
undo speed
View
AUX interface view
Default Level
2: System level
Parameters
speed-value: Transmission speed (in bps). This argument can be 300, 600, 1200, 2400, 4800, 9600,
19,200, 38,400, 57,600, 115,200 and defaults to 9,600.
Description
Use the speed command to set the transmission speed of the user interface.
Use the undo speed command to revert to the default transmission speed.
After you use the speed command to configure the transmission speed of the AUX user interface, you
must change the corresponding configuration of the terminal emulation program running on the PC, to
keep the configuration consistent with that on the switch.
Examples
# Set the transmission speed of the AUX user interface to 9600 bps.
1-19