Stack Ip-Pool; Stack Role Master - H3C S5120-SI Series Command Reference Manual

stack ip-pool

Syntax
stack ip-pool ip-address { mask | mask-length }
undo stack ip-pool
View
System view
Default Level
2: System level
Parameters
ip-address: Start IP address of the stack IP address pool.
mask: IP address mask, in dotted decimal notation. The system ANDs the mask with the specified IP
address to get a network segment address, which will be the private IP address pool providing IP
addresses for the slave devices.
mask-length: IP address mask length, based on which a network segment address is calculated, which
will be the private IP address pool providing IP addresses for the slave devices.
Description
Use the stack ip-pool command to configure a private IP address pool for a stack.
Use the undo stack ip-pool command to remove the configured private IP address pool.
By default, no private IP address pool is configured for a stack.
Before creating a stack, you need to configure a private IP address pool for the stack, so that when a
slave device joins the stack, the master device can assign an available IP address to it automatically.
Examples
# Configure a private IP address pool containing IP addresses from 192.168.1.1 to 192.168.1.255 for a
stack.
<Sysname> system-view
[Sysname] stack ip-pool 192.168.1.1 24

stack role master

Syntax
stack role master
undo stack role master
View
System view
Default Level
2: System level
1-3