Archive Configuration Location - H3C S5120-SI Series Command Reference Manual

Hide thumbs Also See for S5120-SI Series:

Table of Contents

Default Level

3: Manage level

minutes: Specifies the interval for automatically saving the current running configuration, in minutes.

The value ranges from 10 to 525,600 (365 days).

Use the archive configuration interval command to enable the automatic saving of the current

running configuration and set the interval.

Use the undo archive configuration interval command to restore the default.

By default, the system does not save the current running configuration automatically.

After the execution of this command, the system saves the current running configuration with the

specified filename to the specified path at a specified interval (the value of the minutes argument).

Configure an automatic saving interval according to the storage medium performance and the

frequency of configuration modification:

If the configuration of the device does not change frequently, you are recommended to save the

current running configuration manually as needed

If a low-speed storage medium (such as a flash) is used, you are recommended either to save the

current running configuration manually, or to configure automatic saving with an interval longer

than 1,440 minutes (24 hours).

Note the following:

Before executing the archive configuration interval command, you must configure the filename prefix

and path of the saved configuration file by using the archive configuration location command.

# Configure the system to save the current running configuration every 60 minutes.

<Sysname> system-view

[Sysname] archive configuraion interval 60

Info: Archive files will be saved every 60 minutes.