Poe Disconnect - H3C S5120-SI Series Command Reference Manual

View
Any view
Default Level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display poe-profile interface command to display all information of the configurations and
applications of the PoE configuration file that currently takes effect on the specified PoE interface.
Examples
# Display all information of the configurations and applications of the current PoE configuration file
applied to GigabitEthernet1/0/1.
<Sysname> display poe-profile interface gigabitethernet 1/0/1
Poe-profile
forIPphone
Because not all the configurations of a PoE configuration file can be applied successfully, only the
configurations that currently take effect on the interface are displayed. For the descriptions for other
fields, refer to Table

poe disconnect

Syntax
poe disconnect { ac | dc }
undo poe disconnect
View
System view
Default Level
2: System level
Parameters
ac: Specifies the PD disconnection detection mode as ac.
dc: Specifies the PD disconnection detection mode as dc.
Description
Use the poe disconnect command to configure a PD disconnection detection mode.
Use the undo poe disconnect command to restore the default.
The default PD disconnection detection mode is ac.
Note that change to the PD disconnection detection mode may lead to power-off of some PDs.
Index ApplyNum Interface
1 6 GE1/0/1
1-6.
Current Configuration
poe enable
poe priority critical
1-11