Lldp Admin-Status; Lldp Check-Change-Interval - H3C S5120-SI Series Command Reference Manual

lldp admin-status

Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Layer 2 Ethernet port view, port group view
Default level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode receives LLDPDUs only.
tx: Specifies the Tx mode. A port in this mode sends LLDPDUs only.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use the lldp admin-status command to specify the LLDP operating mode for a port or all the ports in a
port group.
Use the undo lldp admin-status command to restore the default LLDP operating mode.
The default LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp admin-status rx

lldp check-change-interval

Syntax
lldp check-change-interval interval
undo lldp check-change-interval
View
Layer 2 Ethernet port view, port group view
Default level
2: System level
Parameters
interval: LLDP polling interval to be set, in the range 1 to 30 (in seconds).
1-14