Snmp-Host - H3C S5120-SI Series Command Reference Manual

Description
Use the reboot member command to reboot a specified member device.
Note that this command can be executed only on the management device.
Examples
# Reboot the member device numbered 2 on the management device.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] reboot member 2

snmp-host

Syntax
snmp-host ip-address [ community-string read string1 write string2 ]
undo snmp-host
View
Cluster view
Default Level
3: Manage level
Parameters
ip-address: IP address of an SNMP host.
string1: Community name of read-only access, a string of 1 to 26 characters.
string2: Community name of read-write access, a string of 1 to 26 characters.
Description
Use the snmp-host command to configure a shared SNMP host for a cluster.
Use the undo snmp-host command to cancel the SNMP host configuration.
By default, no SNMP host is configured for a cluster.
Note that this command can be executed on the management device only.
Examples
# Configure a shared SNMP host for the cluster on the management device.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] snmp-host 1.0.0.9 community-string read 123 write 456
1-44