Igmp-Snooping Query-Interval; Igmp-Snooping Report Source - H3C S5120-SI Series Command Reference Manual

igmp-snooping query-interval

Syntax
igmp-snooping query-interval interval
undo igmp-snooping query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: Interval between IGMP general queries, in seconds. The effective range is 2 to 300.
Description
Use the igmp-snooping query-interval command to configure the interval between IGMP general
queries.
Use the undo igmp-snooping query-interval command to restore the default setting.
By default, the IGMP general query interval is 60 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands:
max-response-time, max-response-time.
Examples
# Enable IGMP snooping and set the interval between IGMP general queries to 20 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping query-interval 20
igmp-snooping report source-ip
Syntax
igmp-snooping report source-ip { ip-address | current-interface }
undo igmp-snooping report source-ip
View
VLAN view
Default Level
2: System level
igmp-snooping enable,
1-20
igmp-snooping querier, igmp-snooping