H3C S5120-SI Series Command Reference Manual page 335

Hide thumbs Also See for S5120-SI Series:

Table of Contents

Outbound interface for packets to be forwarded along the route

Backup next hop

Backup outbound interface

The next hop address obtained through routing recursion

Neighboring address determined by Routing Protocol

Route status:

Time for which the route has been in the routing table, in the sequence of hour,

minute, and second from left to right.

This is an active unicast route.

This route can be advertised.

This route is deleted.

This is an indirect route.

Number of holddown routes.

The route was discovered by an Interior Gateway Protocol

The route is not advertised when the router advertises routes

based on policies.

Normally, among routes to a destination, the route with the

highest priority is installed into the core routing table and

advertised, while a NotInstall route cannot be installed into the

core routing table but may be advertised.

The packets matching a Reject route will be dropped.

Besides, the router sends ICMP unreachable messages to

the sources of the dropped packets. The Reject routes are

usually used for network testing.

A static route is not lost when you perform the save operation

and then restart the router. Routes configured manually are

marked as static.

Unicast routes

Inactive routes

Invalid routes

The route is the WaitQ during route recursion.

The route is in the GotQ during route recursion.

Chapters

Table of Contents