Ntp-Service Broadcast-Server - H3C S5120-SI Series Command Reference Manual

Parameters
None
Description
Use the ntp-service broadcast-client command to configure the device to work in the NTP broadcast
client mode and use the current interface to receive NTP broadcast packets.
Use the undo ntp-service broadcast-client command to remove the configuration.
By default, the device does not work in any NTP operation mode.
Examples
# Configure the device to work in the broadcast client mode and receive NTP broadcast messages on
VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-client

ntp-service broadcast-server

Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
View
Interface view
Default Level
2: System level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to
broadcast clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
version number: Specifies the NTP version, where number is in the range of 1 to 3 and defaults to 3.
Description
Use the ntp-service broadcast-server command to configure the device to work in the NTP broadcast
server mode and use the current interface to send NTP broadcast packets.
Use the undo ntp-service broadcast-server command to remove the configuration.
By default, the device does not work in any NTP operation mode.
Examples
# Configure the device to work in the broadcast server mode and send NTP broadcast messages on
VLAN-interface 1, using key 4 for encryption, and set the NTP version to 3.
<Sysname> system-view
[Sysname] interface vlan-interface 1
1-11