Display Nandflash Page-Data - H3C S5120-SI Series Command Reference Manual

No
------------------------------
badblock(0)
badblock(1)
badblock(2)
3200 block(s) total, 3 block(s) bad.
Table 1-3 display nandflash badblock-location command output description
Field
No
Physical block
3200 block(s) total, 3 block(s)
bad.

display nandflash page-data

Syntax
display nandflash page-data page-value
View
Any view
Default Level
1: Monitor level
Parameters
page-value: Serial number of a physical page.
Description
Use the display nandflash page-data command to display the data on the specified physical page in
the NAND flash memory.
This command is always used in combination with the display nandflash file-location command to
check the correctness of the data in the NAND flash memory.
Examples
# Display the content of the file test.cfg which is saved in the NAND flash memory.
<Sysname> display nandflash file-location test.cfg
Logical Chunk
---------------------------
chunk(0)
chunk(1)
chunk(2)
filename: test.cfg
<Sysname> display nandflash page-data 1236
Physical block
1234
1235
1236
Serial number of the bad blocks
Serial number of the physical pages on which there are bad
blocks
Total number of blocks and bad blocks in the NAND flash memory
Physical Page
1234
1236
1235
Description
1-6