H3C S5120-SI Series Command Reference Manual page 862

Field
Port IEEE class
Port Detection Status
Port Power Mode
Port Current Power
Port Average Power
Port Peak Power
Port Max Power
Port Current
Port Voltage
Port PD Description
# Display the state of all PoE interfaces.
<Sysname> display poe interface
Interface Status
GE1/0/1 enabled
GE1/0/2 enabled
GE1/0/3 enabled
GE1/0/4 enabled
GE1/0/5 enabled
GE1/0/6 enabled
GE1/0/7 disabled low
--- 2 port(s) on,
Table 1-3 display poe interface command output description
Field
Interface
Priority CurPower Operating
(W)
low 4.4
critical 0.0
low 0.0
critical 0.0
low 4.0
low 0.0
0.0
8.4(W) consumed, 361.6(W) Remaining ---
1-5
Description
Port operating status varies with devices.
PD power class: 0, 1, 2, 3, 4, and -
- indicates not supported.
Power detection state of a PoE interface:
disabled: The PoE function is disabled.
searching: The PoE interface is searching
for the PD.
delivering-power: The PoE interface is
supplying power for the PD.
fault: There is a fault defined in 802.3af.
test: The PoE interface is under test.
other-fault: There is a fault other than
defined in 802.3af.
pd-disconnect: The PD is disconnected.
Power mode of a PoE interface:
signal: Power is supplied over signal cables.
spare: Power is supplied over spare cables.
Current power of a PoE interface, including PD
consumption power and transmission loss.
Average power of a PoE interface
Peak power of a PoE interface
Maximum power of a PoE interface
Current of a PoE interface
Voltage of a PoE interface
Description of the PD connected to the PoE
interface, which is used to identify the type and
location of the PD.
IEEE Detection
Status class Status
on 1 delivering-power
on - disabled
on - disabled
on - searching
on 2 delivering-power
on - disabled
off - fault
Description
Shortened form of a PoE interface