System-Failure - H3C S5120-SI Series Command Reference Manual

This command reboots the device after the specified delay time, thus resulting in service interruption.
Please use it with caution.
Examples
# Configure the device to reboot in 88 minutes (supposing the current time is 11:48).
<Sysname> schedule reboot delay 88
Reboot system at 13:16 06/06/2006(in 1 hour(s) and 28 minute(s)). confirm? [Y/N]:
# If you have used the terminal logging command to enable the log display function on the terminal
before setting a reboot time, the system will automatically display related log information after you enter
y. By default, the log display function is enabled on the terminal.
<Sysname>
%Jun 6 11:48:44:860 2006 Sysname CMD/4/REBOOT:
vty0(192.168.1.54): Set schedule reboot parameters at 11:48:44 06/06/2006, and system will
reboot at 13:16 06/06/2006.

system-failure

Syntax
system-failure { maintain | reboot }
undo system-failure
View
System view
Default Level
3: Manage level
Parameters
maintain: Specifies that when the system detects any software abnormality, it maintains the current
situation, and does not take any measure to recover itself.
reboot: Specifies that when the system detects any software abnormality, it recovers itself through
automatic reboot.
Description
Use the system-failure command to configure the exception handling method.
By default, the system adopts the reboot method to handle exceptions.
Examples
# Set the exception handling method to reboot.
<Sysname> system-view
[Sysname] system-failure reboot
1-26