Dhcp Relay Information Remote-Id Format-Type; Dhcp Relay Information Remote-Id String - H3C S5120-SI Series Command Reference Manual

<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay information enable
[Sysname-Vlan-interface1] dhcp relay information strategy replace
[Sysname-Vlan-interface1] dhcp relay information format verbose

dhcp relay information remote-id format-type

Syntax
dhcp relay information remote-id format-type { ascii | hex }
undo dhcp relay information remote-id format-type
View
Interface view
Default Level
2: System view
Parameters
ascii: Specifies the code type for the remote ID sub-option as ascii.
hex: Specifies the code type for the remote ID sub-option as hex.
Description
Use the dhcp relay information remote-id format-type command to configure the code type for the
non-user-defined remote ID sub-option.
Use the undo dhcp relay information remote-id format-type command to restore the default.
By default, the code type for the remote ID sub-option is HEX.
Note that:
This command applies to configuring the non-user-defined remote ID sub-option only. After you
configure the padding content for the remote ID sub-option using the dhcp relay information
remote-id string command, ASCII is adopted as the code type.
Related commands: display dhcp relay information.
Examples
# Configure the code type for the non-user-defined remote ID sub-option as ascii.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay information remote-id format-type ascii

dhcp relay information remote-id string

Syntax
dhcp relay information remote-id string { remote-id | sysname }
undo dhcp relay information remote-id string
1-5