Rule (Pki Cert Acp View) - H3C S5120-SI Series Command Reference Manual

Use the undo root-certificate fingerprint command to remove the configuration.
By default, no fingerprint is configured for verifying the validity of the CA root certificate.
Examples
# Configure an MD5 fingerprint for verifying the validity of the CA root certificate.
<Sysname> system-view
[Sysname] pki domain 1
[Sysname-pki-domain-1] root-certificate fingerprint md5 12EF53FA355CD23E12EF53FA355CD23E
# Configure a SHA1 fingerprint for verifying the validity of the CA root certificate.
[Sysname-pki-domain-1]
D1526110AAD7527FB093ED7FC037B0B3CDDDAD93

rule (PKI CERT ACP view)

Syntax
rule [ id ] { deny | permit } group-name
undo rule { id | all }
View
PKI certificate access control policy view
Default Level
2: System level
Parameters
id: Number of the certificate attribute access control rule, in the range 1 to 16. The default is the smallest
unused number in this range.
deny: Indicates that a certificate whose attributes match an attribute rule in the specified attribute group
is considered invalid and denied.
permit: Indicates that a certificate whose attributes match an attribute rule in the specified attribute
group is considered valid and permitted.
group-name: Name of the certificate attribute group to be associated with the rule, a case-insensitive
string of 1 to 16 characters. It cannot be "a", "al" or "all".
all: Specifies all access control rules.
Description
Use the rule command to create a certificate attribute access control rule.
Use the undo rule command to delete a specified or all access control rules.
By default, no access control rule exists.
Note that a certificate attribute group must exist to be associated with a rule.
Examples
# Create an access control rule, specifying that a certificate is considered valid when it matches an
attribute rule in certificate attribute group mygroup.
root-certificate
1-25
fingerprint sha1