Delete-Member - H3C S5120-SI Series Command Reference Manual

The command can be executed once on the management device only. This configuration will be
synchronized to member devices on the whitelist, which is equal to configuring multiple member
devices at one time.
SNMPv3 group user will be retained if a cluster is dismissed or a member device is deleted from
the whitelist.
If the same username as the current one has been configured on a member device, the current
username will replace the original one on the member device.
Examples
# Add a user wang to the SNMP group snmpgroup, set the security level to authentication-needed and
specify the authentication protocol as HMAC-MD5-96 and authentication password as pass.
<aaa_0.Sysname> system-view
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] cluster-snmp-agent usm-user v3 wang snmpgroup authentication-mode
md5 pass

delete-member

Syntax
delete-member member-number [ to-black-list ]
View
Cluster view
Default Level
2: System level
Parameters
member-number: Number of a member device in a cluster, in the range 1 to 255.
to-black-list: Adds the device removed from a cluster to the blacklist to prevent it from being added to
the cluster again.
Description
Use the delete-member command to remove a member device from the cluster.
Note that:
This command can be executed only on the management device.
If you only remove a member device from the cluster without adding it to the blacklist, the device
will be automatically added to the cluster again.
Examples
# Remove the member device numbered 2 from the cluster on the management device.
<Sysname> system-view
[Sysname] cluster
[Sysname-cluster] ip-pool 10.1.1.1 24
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster] delete-member 2 to-black-list
1-28