Lldp Compliance Admin-Status Cdp - H3C S5120-SI Series Command Reference Manual

Description
Use the lldp check-change-interval command to enable LLDP polling and set the polling interval.
Use the undo lldp check-change-interval command to restore the default.
By default, LLDP polling is disabled.
Examples
# Enable LLDP polling on GigabitEthernet 1/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp check-change-interval 30

lldp compliance admin-status cdp

Syntax
lldp compliance admin-status cdp { disable | txrx }
View
Layer 2 Ethernet port view, port group view
Default Level
2: System level
Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP neither receives nor transmits CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Description
Use the lldp compliance admin-status cdp command to configure the operating mode of
CDP-compatible LLDP on a port or port group.
By default, CDP-compatible LLDP operates in disable mode.
To have your device work with Cisco IP phones, you must enable CDP-compatible LLDP globally and
then configure CDP-compatible LLDP to operate in TxRx mode on the specified port(s).
Related commands: lldp compliance cdp.
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp compliance admin-status cdp txrx
1-15