Port Trunk Pvid - H3C S5120-SI Series Command Reference Manual

Please wait........... Done.
# Assign the trunk Layer 2 aggregate interface Bridge-aggregation 1 to VLAN 2, assuming that
Bridge-aggregation 1 does not have member ports.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type trunk
[Sysname-Bridge-Aggregation1] port trunk permit vlan 2
Please wait... Done.
# Assign the trunk Layer 2 aggregate interface Bridge-aggregation 1 to VLAN 13 and VLAN 15.
Among the member ports of the aggregation group corresponding to Bridge-aggregation 1,
GigabitEthernet1/0/2 is an access port, and GigabitEthernet1/0/3 is a trunk port.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type trunk
[Sysname-Bridge-Aggregation1] port trunk permit vlan 13 15
Please wait... Done.
Error: Failed to configure on interface GigabitEthernet1/0/2! This port is not a Trunk port!
Configuring GigabitEthernet1/0/3... Done.
Among the output fields above, the message "Please wait... Done" indicates that the configuration on
Bridge-aggregation 1 succeeded; "Error: Failed to configure on interface GigabitEthernet1/0/2! This
port is not a Trunk port!" indicates that the configuration failed on GigabitEthernet1/0/2 because
GigabitEthernet1/0/2 was not a trunk port; "Configuring GigabitEthernet1/0/3... Done" indicates that the
configuration on GigabitEthernet1/0/3 succeeded.

port trunk pvid

Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
vlan-id: VLAN ID, in the range of 1 to 4094
Description
Use the port trunk pvid command to configure the default VLAN ID for the trunk port.
Use the undo port trunk pvid command to restore the default.
By default, the default VLAN of a trunk port is VLAN 1.
You can use a nonexistent VLAN as the default VLAN for a trunk port. Removing the default VLAN of a
trunk port with the undo vlan command does not affect the setting of the default VLAN on the port.
1-17