Reset Dhcp-Snooping - H3C S5120-SI Series Command Reference Manual

View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display dhcp-snooping trust command to display information about trusted ports.
Related commands: dhcp-snooping trust.
Examples
# Display information about trusted ports.
<Sysname> display dhcp-snooping trust
DHCP Snooping is enabled.
DHCP Snooping trust becomes active.
Interface
=========================
GigabitEthernet1/0/1
The above output shows that DHCP snooping is enabled, DHCP snooping trust is active, and port
GigabitEthernet1/0/1 is trusted.

reset dhcp-snooping

Syntax
reset dhcp-snooping { all | ip ip-address }
View
User view
Default Level
1: Monitor level
Parameters
all: Clears all DHCP snooping entries.
ip ip-address: Clears the DHCP snooping entries of the specified IP address.
Description
Use the reset dhcp-snooping command to clear DHCP snooping entries.
DHCP snooping entries on all slots will be cleared after you execute this command.
Related commands: display dhcp-snooping.
Trusted
============
Trusted
3-11