Host-Aging-Time (Igmp-Snooping View); Igmp-Snooping - H3C S5120-SI Series Command Reference Manual

[Sysname-acl-basic-2000] rule permit source 225.1.1.1 0
[Sysname-acl-basic-2000] quit
[Sysname] igmp-snooping
[Sysname-igmp-snooping] group-policy 2000 vlan 2

host-aging-time (IGMP-Snooping view)

Syntax
host-aging-time interval
undo host-aging-time
View
IGMP-Snooping view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in seconds. The effective range is 200 to 1,000.
Description
Use the host-aging-time command to configure the aging time of dynamic member ports globally.
Use the undo host-aging-time command to restore the default setting.
By default, the aging time of dynamic member ports is 260 seconds.
This command works only on IGMP snooping–enabled VLANs.
Related commands: igmp-snooping host-aging-time.
Examples
# Set the aging time of dynamic member ports globally to 300 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] host-aging-time 300

igmp-snooping

Syntax
igmp-snooping
undo igmp-snooping
View
System view
Default Level
2: System level
1-6