Ssh2.0 Client Configuration Commands - H3C S5120-SI Series Command Reference Manual

assign publickey keyname: Assigns an existing public key to an SSH user. keyname indicates the
name of the client public key and is a string of 1 to 64 characters.
work-directory directory-name: Specifies the working directory for an SFTP user. directory-name
indicates the name of the working directory and is a string of 1 to 135 characters.
Description
Use the ssh user command to create an SSH user and specify the service type and authentication
method.
Use the undo ssh user command to delete an SSH user.
Note that:
For a publickey authentication user, you must configure the username and the public key on the
device. For a password authentication user, you can configure the account information on either
the device or the remote authentication server such as a RADIUS server.
If you use the ssh user command to configure a public key for a user who has already had a public
key, the new one overwrites the old one.
You can change the authentication method and public key of an SSH user when the user is
communicating with the SSH server. However, your changes take effect only after the user logs out
and logs in again.
If an SFTP user has been assigned a public key, it is necessary to set a working folder for the user.
The working folder of an SFTP user is subject to the user authentication method. For a user using
only password authentication, the working folder is the AAA authorized one. For a user using only
publickey authentication or using both publickey authentication and password authentication, the
working folder is the one set by using the ssh user command.
Related commands: display ssh user-information.
Examples
# Create an SSH user named user1, setting the service type as sftp, the authentication method as
publickey, the working directory of the SFTP server as flash, and assigning a public key named key1
to the user.
<Sysname> system-view
[Sysname] ssh user user1 service-type sftp authentication-type publickey assign publickey
key1 work-directory flash:

SSH2.0 Client Configuration Commands

display ssh client source
Syntax
display ssh client source
View
Any view
Default Level
1: Monitor level
1-8