Time-Range - H3C S5120-SI Series Command Reference Manual

Description
Use the step command to set a rule numbering step for an ACL.
Use the undo step command to restore the default.
By default, the rule numbering step is 5.
Related commands: display acl.
Examples
# Set the rule numbering step to 2 for basic ACL 2000.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] step 2
# Set the rule numbering step to 2 for advanced ACL 3000.
<Sysname> system-view
[Sysname] acl number 3000
[Sysname-acl-adv-3000] step 2
# Set the rule numbering step to 2 for Ethernet frame header ACL 4000.
<Sysname> system-view
[Sysname] acl number 4000
[Sysname-acl-ethernetframe-4000] step 2

time-range

Syntax
time-range time-range-name { start-time to end-time days [ from time1 date1 ] [ to time2 date2 ] | from
time1 date1 [ to time2 date2 ] | to time2 date2 }
undo time-range time-range-name [ start-time to end-time days [ from time1 date1 ] [ to time2 date2 ]
| from time1 date1 [ to time2 date2 ] | to time2 date2 ]
View
System view
Default Level
2: System level
Parameters
time-range-name: Assign a name for a time range. The name is a case insensitive string of 1 to 32
characters. It must start with an English letter and, to avoid confusion, cannot be all.
start-time to end-time: Specifies a periodic time range. Both start-time and end-time are in hh:mm
format (24-hour clock), and each value ranges from 00:00 to 23:59. The end time must be greater than
the start time.
days: Specifies the day or days of the week on which the periodic time range is valid. You may specify
multiple values, in words or in digits, separated by spaces, but make sure that they do not overlap. The
values are ANDed. These values can take one of the following forms:
1-17