Lldp Management-Address-Format String; Lldp Management-Address-Tlv - H3C S5120-SI Series Command Reference Manual

The TTL multiplier defaults to 4.
You can set the TTL of the local device information by configuring the TTL multiplier.
The TTL of the information about a device is determined by the following expression:
Note that the TTL can be up to 65535 seconds. TTLs longer than 65535 will be rounded off to 65535
seconds.
Related commands: lldp timer tx-interval.
Examples
# Set the TTL multiplier to 6.
<Sysname> system-view
[Sysname] lldp hold-multiplier 6

lldp management-address-format string

Syntax
lldp management-address-format string
undo lldp management-address-format
View
Layer 2 Ethernet port view, port group view
Default Level
2: System level
Parameters
None
Description
Use the lldp management-address-format string command to encapsulate the management
address in the form of strings in TLVs.
Use the undo lldp management-address-format command to restore the default.
By default, the management address is encapsulated in the form of numbers in TLVs.
Examples
# Configure GigabitEthernet 1/0/1 to encapsulate the management address in the form of strings in
management address TLVs.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp management-address-format string

lldp management-address-tlv

Syntax
lldp management-address-tlv [ ip-address ]
TTL multiplier × LLDPDU transmit interval
1-19