H3C S5120-SI Series Command Reference Manual page 137

system-capability: Advertises system capabilities TLVs.
system-description: Advertises system description TLVs.
system-name: Advertises system name TLVs.
dot1-tlv: Advertises IEEE 802.1 organizationally specific LLDP TLVs.
port-vlan-id: Advertises port VLAN ID TLVs.
protocol-vlan-id: Advertises port and protocol VLAN ID TLVs.
vlan-name: Advertises VLAN name TLVs.
vlan-id: ID of the VLAN in the TLVs to be advertised. This argument ranges from 1 to 4094 and defaults
to the least VLAN ID on the port.
dot3-tlv: Advertises IEEE 802.3 organizationally specific LLDP TLVs.
link-aggregation: Advertises link aggregation TLVs.
mac-physic: Advertises MAC/PHY configuration/status TLVs.
max-frame-size: Advertises maximum frame size TLVs.
power: Advertises power via MDI TLVs.
med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory: Advertises hardware revision TLVs, firmware revision TLVs, software revision TLVs, serial
number TLVs, manufacturer name TLVs, model name TLVs, and asset ID TLVs.
location-id: Advertises location identification TLVs.
civic-address: Inserts the normal address information about the network device in location
identification TLVs .
device-type: Device type value, in the range of 0 to 2. A value of 0 specifies DHCP server; a value of 1
specifies switch, and a value of 2 specifies LLDP-MED endpoint.
country-code: Country code, confirming to ISO 3166.
{ ca-type ca-value }&<1-10>: Configures address information, where ca-type represents the address
information type, in the range 0 to 255, ca-value represents address information, which is a string of 1 to
250 characters, and &<1-10> indicates that you can enter up to ten such parameters.
elin-address: Inserts telephone numbers for urgencies in location identification TLVs.
tel-number: Telephone number for urgencies, a string of 10 to 25 characters.
network-policy: Advertises network policy TLVs.
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Description
Use the lldp tlv-enable command to configure the types of advertisable TLVs for a port or all the ports
in a port group.
Use the undo lldp tlv-enable command to disable the advertising of specific types of TLVs.
By default, all types of LLDP TLVs, except location identification TLVs, are advertisable on a Layer 2
Ethernet port.
Note that:
1-24