Display This - H3C S5120-SI Series Command Reference Manual

CTRL_W Delete the word left of the cursor.
CTRL_X Delete all characters up to the cursor.
CTRL_Y Delete all characters after the cursor.
CTRL_Z Return to the User View.
CTRL_] Kill incoming connection or redirect connection.
ESC_B Move the cursor one word back.
ESC_D Delete remainder of word.
ESC_F Move the cursor forward one word.
ESC_N Move the cursor down a line.
ESC_P Move the cursor up a line.
ESC_< Specify the beginning of clipboard.
ESC_> Specify the end of clipboard.

display this

Syntax
display this [ by-linenum ]
View
Any view
Default Level
1: Monitor level
Parameters
by-linenum: Specifies to display the number of each line.
Description
Use the display this command to display the validated configuration information under the current
view.
After finishing a set of configurations under a view, you can use the display this command to check
whether the configuration takes effect.
Note that:
A parameter is not displayed if it has the default configuration.
A parameter is not displayed if the configuration has not taken effect.
Execution of this command in any user interface view displays the valid configuration in all the user
interfaces.
Execution of this command in any VLAN view displays the configurations of all the created VLANs.
Examples
# Display the valid configuration information on interface GigabitEthernet1/0/1 (the output information
depends on the current configuration of the device).
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-gigabitethernet 1/0/1] display this
#
1-13