Copyright-Info Enable - H3C S5120-SI Series Command Reference Manual

When you configure the command-privilege command, the value of the command argument must
be a complete form of the specified command, that is, you must enter all needed keywords and
arguments of the command. The argument should be in the value range. For example, the default
level of the tftp server-address { get | put | sget } source-filename [ destination-filename ] [ source
{ interface interface-type interface-number | ip source-ip-address } ] command is 3; after the
command-privilege level 0 view shell tftp 1.1.1.1 put a.cfg command is executed, when users
with the user privilege level of 0 log in to the device, they can execute the tftp server-address put
source-filename command (such as the tftp 192.168.1.26 put syslog.txt command); users with the
user privilege level of 0 cannot execute the command with the get, sget or source keyword, and
cannot specify the destination-filename argument.
When you configure the undo command-privilege view command, the value of the command
argument can be an abbreviated form of the specified command, that is, you only need to enter the
keywords at the beginning of the command. For example, after the undo command-privilege
view system ftp command is executed, all commands starting with the keyword ftp (such as ftp
server acl, ftp server enable, and ftp timeout) will be restored to the default level; if you have
modified the command level of commands ftp server enable and ftp timeout, and you want to
restore only the ftp server enable command to its default level, you should use the undo
command-privilege view system ftp server command.
If you modify the command level of a command in a specified view from the default command level
to a lower level, remember to modify the command levels of the quit command and the
corresponding command that is used to enter this view. For example, the default command level of
commands interface and system-view is 2 (system level); if you want to make the interface
command available to the users with the user privilege level of 1, you need to execute the following
three commands: command-privilege level 1 view shell system-view, command-privilege level
1 view system interface ethernet 1/1, and command-privilege level 1 view system quit, so that
the login users with the user privilege level of 1 can enter system view, execute the interface
ethernet command, and then return to user view.
Examples
# Set the command level of the system-view command in user view to 3. (By default, users with the
user privilege level of 2 or 3 can use the system-view command after login; after the following
configuration, only users with the user privilege level of 3 can use this command to enter system view
and configure the device. Therefore, the device security is improved.)
<Sysname> system-view
[Sysname] command-privilege level 3 view shell system-view

copyright-info enable

Syntax
copyright-info enable
undo copyright-info enable
View
System view
Default Level
3: Manage level
1-6