Lldp Notification Remote-Change Enable - H3C S5120-SI Series Command Reference Manual

undo lldp management-address-tlv
View
Layer 2 Ethernet port view, port group view
Default level
2: System level
Parameters
ip-address: Management address to be advertised in LLDPDUs.
Description
Use the lldp management-address-tlv command to enable management address advertising and set
the management address.
Use the undo lldp management-address-tlv command to disable management address advertising in
LLDPDUs.
By default, the management address is sent through LLDPDUs, and the management address is the
primary IP address of the VLAN with the smallest VLAN ID among the VLANs whose packets are
permitted on the port. If the primary IP address is not configured, the management address is 127.0.0.1.
Note that: an LLDPDU carries only one management address TLV. If you set the management address
repeatedly, the latest one takes effect.
Examples
# Set the management address to 192.6.0.1 for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp management-address-tlv 192.6.0.1

lldp notification remote-change enable

Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
View
Layer 2 Ethernet port view, port group view
Default level
2: System level
Parameters
None
Description
Use the lldp notification remote-change enable command to enable LLDP trapping for a port or all
the ports in a port group.
1-20