Terminal Monitor - H3C S5120-SI Series Command Reference Manual

The log information is displayed (using the terminal logging command) only after the monitoring
of system information is enabled on the current terminal first (using the terminal monitor
command).
The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the display of log information on the terminal
restores the default.
Examples
# Disable the display of log information on the current terminal.
<Sysname> undo terminal logging
Info: Current terminal logging is off.

terminal monitor

Syntax
terminal monitor
undo terminal monitor
View
User view
Default Level
1: Monitor level
Parameters
None
Description
Use the terminal monitor command to enable the monitoring of system information on the current
terminal.
Use the undo terminal monitor command to disable the monitoring of system information on the
current terminal.
By default, monitoring of the system information on the console is enabled and that on the monitor
terminal is disabled.
Note that:
You need to configure the terminal monitor command before you can display the log, trap, and
debugging information.
Configuration of the undo terminal monitor command automatically disables the monitoring of log,
trap, and debugging information.
The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the monitoring of system information on the terminal
restores the default.
Examples
# Enable the monitoring of system information on the current terminal.
<Sysname> terminal monitor
1-30