Arp Detection Configuration Commands; Arp Detection Enable; Arp Detection Mode - H3C S5120-SI Series Command Reference Manual

Examples
# Specify the ARP packet rate on GigabitEthernet1/0/1 as 50 pps, and exceeded packets will be
discarded.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] arp rate-limit rate 50 drop

ARP Detection Configuration Commands

arp detection enable

Syntax
arp detection enable
undo arp detection enable
View
VLAN view
Default Level
2: System level
Parameters
None
Description
Use the arp detection enable command to enable ARP detection for the VLAN.
Use the undo arp detection enable command to disable ARP detection for the VLAN.
By default, ARP detection is disabled for a VLAN.
Examples
# Enable ARP detection for VLAN 1.
<Sysname> system-view
[Sysname] vlan 1
[Sysname-Vlan1] arp detection enable

arp detection mode

Syntax
arp detection mode { dhcp-snooping | dot1x | static-bind }
undo arp detection mode { dhcp-snooping | dot1x | static-bind }
View
System view
2-6