H3C S5120-SI Series Command Reference Manual page 861

Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display poe interface command to display the power information of the specified interface.
If no interface is specified, the power information of all PoE interfaces is displayed.
Examples
# Display the power state of GigabitEthernet 1/0/1.
<Sysname> display poe interface gigabitethernet 1/0/1
Port Power Enabled
Port Power Priority
Port Operating Status
Port IEEE Class
Port Detection Status
Port Power Mode
Port Current Power
Port Average Power
Port Peak
Port Max Power
Port Current
Port Voltage
Port PD Description
Table 1-2 display poe interface ethernet command output description
Port Power Enabled
Port Power Priority
Port Operating Status
: enabled
: critical
: on
: 1
: delivering-power
: signal
: 11592
: 11610
: 11684
: 30000
: 244
: 51.7
: IP Phone For Room 101
Field
mW
mW
mW
mW
mA
V
PoE state: enabled/disabled
enabled: PoE is enabled.
disabled: PoE is disabled.
Power priority of the PoE interface:
critical (highest)
high
low
Operating state of a PoE interface:
off: PoE is disabled.
on: Power is supplied for a PoE interface
normally.
power-lack:
power of the PSE is not high enough to
supply power for a critical PoE interface.
power-deny: The PSE refuses to supply
power. The power required by the powered
device (PD) is higher than the configured
power.
power-itself: The external equipment is
supplying power for itself.
power-limit: The PSE is supplying a limited
power. The power required by the PD is
higher than the configured power and the
PSE still supplies the configured power.
1-4
Description
The guaranteed remaining