<Sysname> system-view
[Sysname] stack stack-port 1 gigabitethernet 1/0/1
stack switch-to
Syntax
stack switch-to member-id
View
User view
Default Level
2: System level
Parameters
member-id: ID of the slave device which you want to switch to. The value ranges from 1 to 8.
Description
Use the stack switch-to command to switch from the master device to a slave device to perform
configurations.
This command is used to switch from the master device to a slave device with the user level unchanged.
To switch back, use the quit command.
Examples
# Switch from the master device to slave device 1.
<stack_0.Sysname> stack switch-to 1
<stack_1.Sysname>
1-5