Ntdp Enable - H3C S5120-SI Series Command Reference Manual

Field
Cluster
Administrator MAC
Peer MAC
Peer Port ID
Native Port ID
Speed
Duplex

ntdp enable

Syntax
ntdp enable
undo ntdp enable
View
System view, Ethernet interface view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the ntdp enable command to enable NTDP.
Use the undo ntdp enable command to disable NTDP.
By default, NTDP is enabled globally and on all ports.
Note that:
Execution of the command in system view enables the global NTDP; execution of the command in
interface view enables NTDP of the current port.
Configured in Layer 2 aggregate interface view, the configuration will not take effect on the member
ports of the aggregation group that corresponds to the aggregate interface; configured on a
member port of an aggregation group, the configuration will take effect only after the member port
Role of the device in the cluster:
Member switch of cluster aaa: The device is a member
device of the cluster aaa.
Administrator switch of cluster aaa: The device is the
management device of the cluster aaa.
Candidate switch: The device is a candidate device of
cluster aaa.
Independent switch: The device is connected to the cluster,
but it has not joined the cluster. This may be because the
cluster function is not enabled on the device.
MAC address of the management device
MAC address of a neighbor device
Name of the peer port connected to the local port
Name of the local port to which a neighbor device is connected
Speed of the local port to which a neighbor device is connected
Duplex mode of the local port to which a neighbor device is
connected
1-11
Description