Igmp-Snooping Overflow-Replace - H3C S5120-SI Series Command Reference Manual

View
VLAN view
Default Level
2: System level
Parameters
interval: Maximum response time to IGMP general queries, in seconds. The effective range is 1 to 25.
Description
Use the igmp-snooping max-response-time command to configure the maximum response time to
IGMP general queries in the VLAN.
Use the undo igmp-snooping max-response-time command to restore the default setting.
By default, the maximum response time to IGMP general queries is 10 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, max-response-time, igmp-snooping query-interval.
Examples
# Enable IGMP snooping and set the maximum response time to IGMP general queries to 5 seconds in
VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping max-response-time 5

igmp-snooping overflow-replace

Syntax
igmp-snooping overflow-replace [ vlan vlan-list ]
undo igmp-snooping overflow-replace [ vlan vlan-list ]
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
1-17