Ntp-Service Authentication Enable; Ntp-Service Authentication-Keyid - H3C S5120-SI Series Command Reference Manual

Examples
# Configure the peer devices on subnet 10.10.0.0/16 to have the full access right to the local device.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 10.10.0.0 0.0.255.255
[Sysname-acl-basic-2001] quit
[Sysname] ntp-service access peer 2001

ntp-service authentication enable

Syntax
ntp-service authentication enable
undo ntp-service authentication enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the ntp-service authentication enable command to enable NTP authentication.
Use the undo ntp-service authentication enable command to disable NTP authentication.
By default, NTP authentication is disabled.
Related commands: ntp-service authentication-keyid, ntp-service reliable authentication-keyid.
Examples
# Enable NTP authentication.
<Sysname> system-view
[Sysname] ntp-service authentication enable

ntp-service authentication-keyid

Syntax
ntp-service authentication-keyid keyid authentication-mode md5 value
undo ntp-service authentication-keyid keyid
View
System view
Default Level
2: System level
1-9