H3C S5120-SI Series Command Reference Manual page 210

Router advert:
Router solicit:
Time exceed:
IP header bad:
Timestamp request:
Timestamp reply:
Information request:
Information reply:
Netmask request:
Netmask reply:
Unknown type:
Table 1-1 display ip interface command output description
Field
current state
Line protocol current state
Internet Address
Broadcast address
The Maximum Transmit Unit
input packets, bytes, multicasts
output packets, bytes, multicasts
ARP packet input number:
Request packet:
Reply packet:
Unknown packet:
TTL invalid packet number
0
0
0
0
0
0
0
0
0
0
0
Current physical state of the interface, which can be
Administrative DOWN: Indicates that the interface is
administratively down; that is, the interface is shut down with
the shutdown command.
DOWN: Indicates that the interface is administratively up but
its physical state is down, which may be caused by a
connection or link failure.
UP: Indicates that both the administrative and physical
states of the interface are up.
Current state of the link layer protocol, which can be
DOWN: Indicates that the protocol state of the interface is
down, which is usually because that no IP address is
assigned to the interface.
UP: Indicates that the protocol state of the interface is up.
IP address of an interface followed by:
Primary: Identifies a primary IP address, or
Sub: Identifies a secondary IP address.
Broadcast address of the subnet attached to an interface
Maximum transmission units on the interface, in bytes
Unicast packets, bytes, and multicast packets received on an
interface (the statistics start at the device startup)
Total number of ARP packets received on the interface (the
statistics start at the device startup), including
ARP request packets
ARP reply packets
Unknown packets
Number of TTL-invalid packets received on the interface (the
statistics start at the device startup)
1-2
Description