Reset Counters Interface - H3C S5120-SI Series Command Reference Manual

Use the undo port link-aggregation group command to remove the current Ethernet interface from
the aggregation group to which it currently belongs.
Note that, an Ethernet port can belong to only one aggregation group.
To achieve better load sharing results for data traffic among the member ports of a link aggregation
group, you are recommended to assign ports of the same type (all GE ports or all 10-GE optical ports) to
the link aggregation group.
Examples
# Assign Layer 2 Ethernet interface GigabitEthernet1/0/1 to Layer 2 aggregation group 1.
<Sysname> system-view
[Sysname] interface gigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1] port link-aggregation group 1

reset counters interface

Syntax
reset counters interface [ bridge-aggregation [ interface-number ] ]
View
User view
Default Level
2: System level
Parameters
bridge-aggregation: Clears statistics for Layer 2 aggregate interfaces.
interface-number: Aggregate interface number. If the interface-number argument is not specified, this
command clears statistics of all aggregate interfaces of the specified type.
Description
Use the reset counters interface command to clear the statistics of the specified aggregate interface
or interfaces.
Before collecting statistics for a Layer 2 aggregate interface within a specific period, you need to clear
the existing statistics of the interface.
Note that:
If none of the keywords and argument is specified, this command clears the statistics of all
interfaces in the system.
If only the bridge-aggregation keyword is specified, the command clears the statistics of all Layer
2 aggregate interfaces.
1-12