H3C S5120-SI Series Command Reference Manual page 92

Parameters
None
Description
Use the display link-aggregation summary command to display the summary information of all
aggregation groups.
You may find that information about the remote system for a static link aggregation group is either
displayed as none or not displayed at all. This is normal because this type of aggregation group is not
aware of its partner.
Examples
# Display the summary information of all aggregation groups.
<Sysname> display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e267-6c6a
AGG AGG
Interface Mode
-------------------------------------------------------------------------
BAGG1 S
BAGG10 D
Table 1-3 display link-aggregation summary command output description
Aggregation Interface Type
Aggregation Mode
Loadsharing Type
Actor System ID
AGG Interface
AGG Mode
Partner ID
Select Ports
Unselect Ports
Partner ID
none
0x8000, 000f-e267-57ad
Field
Aggregate interface type:
Aggregation group type:
Loadsharing type:
Local system ID, which comprises the system LACP priority
and the system MAC address
Type and number of the aggregate interface
Aggregation group type
System ID of the partner, which comprises the system LACP
priority and the system MAC address
Total number of selected ports
Total number of unselected ports
Select Unselect
Ports Ports
1 0
2 0
Description
BAGG for Layer 2 aggregate interface
RAGG for Layer 3 aggregate interface
S for static link aggregation
D for dynamic aggregation
Shar for load sharing
NonS for non-load sharing
1-5
Share
Type
Shar
Shar