Dhcpv6 Client Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

25. DHCPv6 Client Commands

25-1 clear ipv6 dhcp client
This command is used to restart the DHCPv6 client on an interface.
clear ipv6 dhcp client INTERFACE-ID
Parameters
INTERFACE-ID
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command restarts the IPv6 DHCP client on the specified interface.
Example
This example shows how to restart the DHCPv6 client for interface VLAN 1.
Switch# clear ipv6 dhcp client vlan1
Switch#
25-2 ipv6 dhcp client pd
This command is used to enable the Dynamic Host Configuration Protocol (DHCP) IPv6 client process to
request the prefix delegation through a specified interface. Use the no form of this command to disable
the request.
ipv6 dhcp client pd {PREFIX-NAME | hint IPV6-PREFIX} [rapid-commit]
no ipv6 dhcp client pd
Parameters
PREFIX-NAME
hint IPV6-PREFIX
rapid-commit
Default
Specifies the VLAN interface to restart the DHCPv6 client.
Specifies the IPv6 general prefix name with a maximum of 32
characters.
Specifies the IPv6 prefix to be sent in the message as a hint.
Specifies to proceed with two-message exchange for prefix delegation.
The rapid-commit option will be filled in the Solicit message to request
two messages handshake.
390