Displaying And Debugging Ntp - Huawei Quidway S3900 Series Operation Manual

Operation Manual -- NTP
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Enter
interface view
Disable
interface
receiving
packets
Caution:
The source IP address in an NTP packet is the address of the sending interface
specified by the ntp-service unicast-server command or the ntp-service
unicast-peer command if you provide the address of the sending interface in these
two commands.
Dynamic connections can only be established when a switch operates in passive
peer mode, NTP broadcast client mode, or NTP multicast client mode. In other
modes, the connections established are static.

1.6 Displaying and Debugging NTP

After the above configuration, you can execute the display command in any view to
display the running status of the NTP configuration, and verify the effect of the
configuration.
Table 1-7 Display and debug NTP
Display the status of NTP service
Display the information about the
sessions maintained by NTP
Display the brief information about
the NTP time servers of the
reference clock sources that the
local device traces to
Command
VLAN
interface
vlan-id
the
from ntp-service
NTP disable
Operation
Huawei Technologies Proprietary
1-13
—
Vlan-interface
Optional
in-interface
By default, a VLAN interface
receives NTP packets.
Command
display ntp-service status
display ntp-service
sessions [ verbose ]
display ntp-service trace
Chapter 1 NTP Configuration
Description
Description
The display
command can
be executed
in any view