Configuration Of Optional Ntp Parameters - Huawei Quidway S3900 Series Operation Manual

Operation Manual -- NTP
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Enter
interface view
Associate
specified key with
the corresponding
NTP server
Note:
The procedures for configuring NTP authentication on the server are the same as that
on the client. Besides, the client and the server must be configured with the same
authentication key.

1.5 Configuration of Optional NTP Parameters

Optional NTP parameters are:
The local VLAN interface that sends NTP packets
The number of the dynamic sessions that can be established locally
Disabling the VLAN interface configured on a switch from receiving NTP packets
Table 1-6 Configure optional NTP parameters
Operation
Enter system view
Configure the local
interface
sends
packets
Configure
number
sessions that can
be
locally
VLAN interface
vlan-id
Broadcast server mode:
ntp-service
broadcast-server
authentication-keyid key-id
a
Multicast server mode:
ntp-service
multicast-server
authentication-keyid key-id
system-view
ntp-service
that
source-interface
NTP
Vlan-interface vlan-id
the
of the ntp-service
max-dynamic-sessions
established number
Huawei Technologies Proprietary
Command
Vlan-interface
Command
1-12
Chapter 1 NTP Configuration
Description
—
In NTP broadcast server
mode and NTP multicast
server mode, you need to
associate the specified key
with the corresponding
NTP server on the server
You can associate an NTP
server with
authentication key while
configuring a switch to
operate in a specific NTP
mode. You can
associate them using this
command after configuring
the NTP mode where a
switch is to operate
Description
—
Optional
Optional
By default, up to 100 dynamic
sessions can be established
locally.
an
also