Setting The Packet Matching Rule; Adding An Outer Vlan Tag - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
By default, the interface type is hybrid.
----End

5.5.3 Setting the Packet Matching Rule

Context
Do as follows on the S9300 where you need to configure selective QinQ.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic classifier classifier-name
A traffic classifier is created and the traffic classifier view is displayed.
Step 3 Run:
if-match vlan-id vlan-id1 [ to vlan-id2 ]
The packet matching rule, that is, the range of VLAN IDs of packets matching the classifier, is
set.
----End

5.5.4 Adding an Outer VLAN Tag

Context
Do as follows on the S9300 where you need to configure selective QinQ.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic behavior behavior-name
A traffic behavior is created and the traffic behavior view is displayed.
Step 3 Run:
nest top-most vlan-id vlan-id
The S9300 is configured to add an outer VLAN tag with the specified VLAN ID to the packets
matching the traffic classifier.
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 QinQ Configuration
5-9