Dial-Up Settings; Setting Wan Abnormal Detection Mode - Huawei B890 Online Help Manual

5.1 Setting WAN Abnormal Detection Mode

When your Smart Hub is using Wireline priority mode to connect to the Internet, if
your Ethernet connection is abnormal, the network connection channel will switch
from Ethernet to wireless automatically. From this page, you can set the detection
mode to determine whether the Ethernet connection is abnormal.
Context
The detection mode has been configured by default, you can keep it or follow the
steps below to change the settings.
Procedure
Step 1 Choose Settings > Dial-up > Dual WAN Settings.
Step 2 From Service detection, select a detect service.




Step 3 Follow the page prompts to enter the parameters if necessary.
Step 4 Click Apply to take effect.
----End
Result
When your Smart Hub is working under Wireline priority mode, and using the
Ethernet connection to access the Internet. If an abnormal wireline is detected, your
Smart Hub will switch to wireless way automatically. Until the Ethernet is detected
back to normal, your Smart Hub will switch to Ethernet automatically again.
Issue 01 (2013-02-05)
DNS lookup: Using DNS lookup to detect whether the Ethernet is abnormal.
Ping default Gateway: Ping the gateway to detect whether the Ethernet is
abnormal.
Ping host name: Ping a host name to detect whether the Ethernet is abnormal.
Ping host address: Ping a host address to detect whether the Ethernet is
abnormal.
HUAWEI B890 4G LTE Smart Hub
5

Dial-up Settings

Online Help
11