Configuring Priority Remark - Huawei Quidway S3900 Series Operation Manual

Operation Manual - QoS&QoS Profile
Quidway S3900 Series Ethernet Switches-Release 1510
II. Configuration procedure
Table 1-6 Set to use the port priority
Operation
Enter system view
Enter Ethernet port
view
Set the port priority
Table 1-7 Set to use the packet priority
Operation
Enter system view
Enter Ethernet port
view
Set the switch to use
the packet priority
III. Configuration example
Set to use the port priority and specify the priority of Ethernet1/0/1 to 7.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface gigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] undo priority-trust cos
[Quidway-GigabitEthernet1/0/1] priority 7
Set the switch to use the 802.1p priority carried in the packet on Ethernet1/0/1.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Ethernet1/0/1
[Quidway-Ethernet1/0/1] priority trust

1.5 Configuring Priority Remark

Refer to 1.1.5 Priority Remark for the introduction to priority remark.
Command
system-view
interface interface-type
interface-number
priority priority-level
Command
system-view
interface interface-type
interface-number
priority trust
Huawei Technologies Proprietary
1-14
Chapter 1 QoS Configuration
Description
—
—
Optional
By default, the
priority is 0
Description
—
—
Through
configuration, the switch
uses the packet priority
instead of the port priority
port
this